Pilot Archive
Thread: My first RE'd part
Page 1 of 2
weaponmaster88
Sun Nov 28, 2004 1:13 am
#1
i finally got a bunch of parts together and found a SW. i RE'd a lvl 8 engine, a lvl 5 armor and a lvl 2 capacitor. heres what i ended up with:
Quantum Ion Engine:
Armor: 637.2
HP: 637.2
RED: 1501.3
Mass: 24031.4
P: 75.2
Y: 75.9
R: 75.5
ETS: 105.1
MandalMotors Custom Heavy Composite Armor
Armor: 896.9
HP: 896.9
Mass: 2279.9
Kuat Systems Engineering Limited Mark I Capacitor
Armor: 121.7
HP: 121.7
RED: 721.8
Mass: 1208.8
CE: 889.3
RR: 34.8
how are these? good? they're being used in an Advanced X-wing
pyro139
Sat Oct 29, 2005 1:01 pm
#2
thats a nice engine, but i always insist that sw gets ent buff first
i have a re'd engine with top speed of 99.9
did i mention it's lvl5?
Durgan_Kael
Sat Oct 29, 2005 2:21 pm
#3
Engine and armor aren't looking too bad...with the right parts, you can do better. The capacitor is pretty shabby though. You should be shooting for upwards of 1200 energy and 48 recharge rate...and higher than that is possible.
Higginsis
Sat Oct 29, 2005 2:57 pm
#4
In a Adv X wing you should have room for at least a L4 REed Capcitor, ideally you want a L6.
Washell
Sat Oct 29, 2005 4:02 pm
#7
pyro139 wrote:
thats a nice engine, but i always insist that sw gets ent buff first
i have a re'd engine with top speed of 99.9
did i mention it's lvl5?
ent buffs don't work on RE'ing
CorenLanra
Sat Oct 29, 2005 4:24 pm
#8
Higginsis wrote:
In a Adv X wing you should have room for at least a L4 REed Capcitor, ideally you want a L6.
I like my level 8 1500+ 50+ regen
weaponmaster88
Sun Oct 30, 2005 12:13 am
#9
i finally got a bunch of parts together and found a SW. i RE'd a lvl 8 engine, a lvl 5 armor and a lvl 2 capacitor. heres what i ended up with:
Quantum Ion Engine:
Armor: 637.2
HP: 637.2
RED: 1501.3
Mass: 24031.4
P: 75.2
Y: 75.9
R: 75.5
ETS: 105.1
MandalMotors Custom Heavy Composite Armor
Armor: 896.9
HP: 896.9
Mass: 2279.9
Kuat Systems Engineering Limited Mark I Capacitor
Armor: 121.7
HP: 121.7
RED: 721.8
Mass: 1208.8
CE: 889.3
RR: 34.8
how are these? good? they're being used in an Advanced X-wing
GerricSablestar
Sun Oct 30, 2005 12:30 am
#10
The recharge on that capacitor seems a little low to me, but other than that some very, very nice parts. I'm especially envious of that engine.
pyro139
Sun Oct 30, 2005 1:11 am
#11
Washell wrote:
pyro139 wrote:
thats a nice engine, but i always insist that sw gets ent buff first
i have a re'd engine with top speed of 99.9
did i mention it's lvl5?
ent buffs don't work on RE'ing
THEY DONT? DOH!!!!! My SW never said anything
again my sw is my other character
weaponmaster88
Sun Oct 30, 2005 6:10 am
#12
Higginsis wrote:
In a Adv X wing you should have room for at least a L4 REed Capcitor, ideally you want a L6.
i was going for 2 lvl 10's and a lvl 8 weapon, so i was running tight on space, but i'll keep a look out for low mass lvl 4's and 6's, my capacitor wasen't the best RE, but i just needed something to hold me over while i loot some more. still ihave never run out of energy with CO3 and WO3.
Zaax1
Sun Oct 30, 2005 7:42 am
#13
hi
on the heavy X, it btr to go for two reward lvl 8 guns and a lvl 10, then two lvl 10 and an 8.
i spent a LOT of time tweeking my X, and overall, if u dont insist on two lvl 10's u will have a much btr ship. the btr cap, DI (unless u got a pre-nerf one - they are rare, but a guildie jsut found one on the bazzar), and and armor , will be more than worth the lower overall damage.
On my freelance shipwrite char) on my krayt, i do indeed have two lvl 10' and a lvl 8 (and the nym lvl 7 as a gunner gun) but it has 30k more mass.
Page 1 of 2