Weaponsmith Archive
Thread: Read 1st Post CU WS Crafting Guide v1.4
Page 1 of 1
Maceey
Tue Aug 30, 2005 8:25 am
#1
good to see the bh loots added i think this was a sticky hehe it might stop some of the questions.
Summerflame
Tue Aug 30, 2005 8:40 am
#2
Maceey wrote:
good to see the bh loots added i think this was a sticky hehe it might stop some of the questions.
It is a sticky
CorenLanra
Wed Aug 31, 2005 3:42 pm
#3
That's why I edited and bumped (knowing that people don't alwasy read stickies).
--Added new Buff info
--Added link to Smuggler FAQ for slicing
--Added new Buff info
--Added link to Smuggler FAQ for slicing
Message Edited by CorenLanra on 08-31-2005 06:15 PM
Argon-Neon
Sun Sep 04, 2005 11:41 pm
#4
Tyranni wrote:
Does anyone know what the Nak'tra crystals from the large spiders on Kashyyyk are used for? The description indicates that they are used during the creation of weapons to make them betterbut I can't seem to be able to use them (Master WS 12 point). They also cannot be used in light sabers (I tried).
During my 2 weeks as a WS, I found a WS quest in the Myddrill Caves. You need to use the crystals to craft 30 Nak'tra crystal knives. stats don't appear to be very good, so i think its only for the quest, though you get to keep the schematic. (yay)
CorenLanra
Wed Sep 07, 2005 4:55 pm
#5
Argon-Neon wrote:
Tyranni wrote:
Does anyone know what the Nak'tra crystals from the large spiders on Kashyyyk are used for? The description indicates that they are used during the creation of weapons to make them better but I can't seem to be able to use them (Master WS 12 point). They also cannot be used in light sabers (I tried).
During my 2 weeks as a WS, I found a WS quest in the Myddrill Caves. You need to use the crystals to craft 30 Nak'tra crystal knives. stats don't appear to be very good, so i think its only for the quest, though you get to keep the schematic. (yay)
I have been meaning to get that info in this guide. I figure there is some walkthrough on gameguides or something. From what I have heard you need to keep making the knife over and over and eventually it comes out quite good.
Page 1 of 1