Weaponsmith Archive
Thread: Question about crafted Geonosian Sword Cores
Page 1 of 1
Thuyker
Sat Jun 05, 2004 6:50 pm
#1
Hi everyone,
I'm trying to makea nice scythe for myself, and had five same-serial yellow cubes and five same-serial solidifying agents I planned to use for it. Ideally, I was hoping to use 1 of each for the schematic, leaving me with four identical sword cores to be used in two scythes. Unfortunately, I got two moderate successes on my experimentation (even with Bespin Port), leaving me with a schematic for a sword core with the following stats: -0.5 Attack Speed, 56-66 Damage, 7 Range, 7/7/7 HAM. Now, I'm considering trying it over again with the remaining cubes, but this would leave me with only enough cores for one scythe. So my question is, is it worth using more cubes/agent to try and get a better core? I'm new to scythe-making and relatively new to WS in general, so I'm not really sure what good stats on a core would be. Thanks in advance!
SexyJabbaTheHutt
Sun Jun 06, 2004 2:22 am
#2
Damage and speed wise, you're dead on (well, for my server). Ham and Range mods you're a little lower, but that's expected if you've gotten some mod successes. I say go for it. If the mats on your server are anything like the ones on mine, the scythe should come out at around 2.5 200-338
Page 1 of 1