Weaponsmith Archive

I am trying to make Geo Sword Cores and I used yellow cubes and solidifying agent to make the schematic. And placed the other 7 (same serial #) of each in the hopper and the correct neutronium steel that I used for the schematic. When I call up the list of ingredients the geo cubes and solidifying agent don't have serial numbers, and when I start the factory it runs for a little while uses some steel then stops.

I am not new to crafting but this one has me stumped. And the maintenance is paid and has plenty of power.

Rorac, Master Merchant, Master Artisan, Master Tailor - Mayor of Acheron
Acheron, Naboo - Friendliest City on Radiant Home to:
Hacks & Crack Bunker Mall -7460 3406 (NEW LOCATION)
Lockheed's Master Shipwright Vendors
Resource, Power, and other vendors also available

are you sure you're using the correct factory schematic?

yes, I can take it out of the factory and it has the serial numbers that matches what I have in the input hopper, but the serial numbers are not there when I put the schematic in the factory and pull up the list of ingredients.

Rorac, Master Merchant, Master Artisan, Master Tailor - Mayor of Acheron
Acheron, Naboo - Friendliest City on Radiant Home to:
Hacks & Crack Bunker Mall -7460 3406 (NEW LOCATION)
Lockheed's Master Shipwright Vendors
Resource, Power, and other vendors also available

What is the message you get when it stops?

Run out of ingredients?

Hopper full?

Something else?

When I run into odd problems like these I can usually fix the issue by redeeding the factory and placing it again.