Weaponsmith Archive

Thread: Risk in crafting 2 lines at once.

SgtSixpack
Sat Mar 26, 2005 3:02 pm
#1

Im not a ws but I would like to be one, Im collecting resources atm and Im posting in this forum cause I assume ws have alot more crafting experience over my current profession. I made a master level saber with the best resources and in a research city with 44.5 crafting station and 14.94 crafting tool having eaten pyrillion cake and bespin port on every experiment.


Ive been reading about the details of the crafting process but Ive not seena post talking about any possible benifit from experimenting 2 different lines at once. When u select 1 point from both lines the right hand bar goes red and reads "5%" [chance to fail]. I tried this method for the hell of it, and ended up with a saber that was equal to the best damage and fc (efficiency) of my prevous best, with slightly lower mind cost (so I assume afraction lower fc without being a whole number).


My question is if there is a risk in this process is there a benifit too?


Also I was tending toexperiement 1 point at a time, if u are lucky enough to get one amazing success when experimenting on more than one point,is this equivalent to an amazing successon each point individually?


Is there abenifit from experimenting onepoint at a time?



138 Assembly 128 Experimentation FS Craft 4404
Weapons Vendor Locations
IGN = Teri' & Terie Pre Cu full Temp jedi cu sbaer 711max.
LookOfDeath
Sat Mar 26, 2005 3:20 pm
#2

I do 3 points at a time



MATHOPOLIS
Executive Founder of :SOR: and Soldier of Valor
Would gladly sacrifice his life for the Rebellion with blood
- V -




Siymon
Sat Mar 26, 2005 4:02 pm
#3

I have not tried it in a long time but iit use to be if you did 2 lines at the same time you got crit failure.



Siymon|Bane'|Noymis|Soruman(Retired)|Tesros(Retired)
Page 1 of 1
Previous Next