Weaponsmith Archive
Thread: jenner and fooman tool
Page 1 of 1
Ethalsar
Fri Jul 30, 2004 7:48 am
#3
It's an Excel spreadsheet (with loads of macros in it!) that can be used by most crafting professions - it keeps track of your resources, compares them to the data from SWGCraft.com and lets you know when you should be getting the harvesters out. It also tells you what the best resources will be to use on any of your schematics - though you can limit it so that precious resources are kept out of the equations.
I mainly use it for resource tracking... been a godsend.
Available from a sticky in the SWGCraft.com weaponsmith forum.
Siymon
Fri Jul 30, 2004 9:13 am
#4
just wish I could figure out how to xfer resources from Fooman 6.0 to the jenner tool.
Siaro
Fri Jul 30, 2004 10:26 am
#5
There are many posts on how to do that on the swgcraft forums. I think you have to move a csv file into the path for JnF. Haven't had to do it myself so I don't know the particulars.
smork
Fri Jul 30, 2004 11:29 am
#7
Siymon wrote:just wish I could figure out how to xfer resources from Fooman 6.0 to the jenner tool.
Do an export from 6.0, then open up the resource backup file you just made in Excel. Save as a CSV. Then open the csv in notepad and replace all commas with semi-colons.
After that it should import into 1.63 and you'll probably get a few resources in red. You just have to change the name since a few got spelling corrections. Laboi cryst. gemstone is one I can think of off-hand.
d0qtrX
Fri Jul 30, 2004 1:09 pm
#8
Siymon wrote:
just wish I could figure out how to xfer resources from Fooman 6.0 to the jenner tool.
Its easy.
Copy from 6.0
Then paste special... values only.
Then make sure your resource names (far left cell) are right else it will dump out when you update/sort.
Ethalsar
Sat Jul 31, 2004 4:23 am
#9
TheRedDarren wrote:
oki doki, so where can i find the said tool?
As I mentioned earlier, in the weaponsmith forum at SWGCraft.com... or click here.
[Edit: Formatting]
Message Edited by Ethalsar on 07-31-2004 12:25 PM
AldaronTavish
Sat Jul 31, 2004 11:25 am
#10
Great tool! Without it I couldn't be a 8 Point WS and compete with the Masters.
Siymon
Sat Jul 31, 2004 6:07 pm
#11
Ok, I tried both of the ways posted here in this forum. Both times I got the Run Time Error 13 Type mismatch. I tried the copy and special paste and the back up, save as csv, change the , to ; and restore. Same error both times. I have foomans 6.0 and jenner 1.63 Any ideas would be apreciated much. 
Page 1 of 1