Weaponsmith Archive

I have a need for speed....

As a relatively new master weaponsmith, I am trying to get a better handle on gun speed. For my un-sliced and un-enhanced weapons, I usually get the comment that I am comparable to other WS's on damage but a bit behind the curve on speed. I've gotten this comment on both my pistols and rifles.

I've been looking over the experimentation allocation again, and speed is tied to damage as I can see it. This is where I usually spend my experimentation points unless someone specifically askes me to lower ham. So, where am I falling behind? As I can see it, it is resources. Does one of the two (conductivity or OQ) go specifically to speed? It would make sense that conductivity would, but I've not been able to extensively test it. I even played around with the regular PH to see how it would compare to the advanced. Didn't make significant inroads.

Any advice welcome.

When you make the Sub-Components BPH barrels feed mechansims it will say 50% dmg 50%spd on the schematic below the resources needed. Ther is only one experimtation value to help enhance the spd that is the one you are doing. If you exp. on other things like durability ham (doh forgot other one) sometimes it will drop spd.

Message Edited by -Strife- on 06-20-2004 06:51 PM

Ahh ther good old should i use adv parts or regular parts..use both make some with and without adv parts..EACH character is played different a master pistoleer dont give a rats behind about spd cause the best spd one can get is 1.0 and they get all them enhancers. While a normal marksmen dont ger that many enhancers they are looking for better dps..lower spd.

Diallo

Master Weaponsmith