Weaponsmith Archive
Thread: Need Help! Factory is eating my krayt tissue!
Seriously .. i was making advanced power handlers last night .. and put 5 krayt tissue of the exact same serial number of the original used in the schematic.. into the ingredients hopper of my factory... double verified the resources that i added... put the tissue in and started the manufacturing.
160 per item... 5 of them .. should be done in 10 minutes right? .. well i come back in 20 .. and its stopped .. nothing in output hopper.
I look at it... and figure it had just stopped... so I started it again. Came back and found it stopped again. And two tissue gone. TRIPLE verified all the ingredients were correct per the schematic... and started it again... It stopped 3 minutes later .. and had eaten another tissue and all the resources as if it had made the item.
There are no messages coming through email from the factory with any kind of errors or problems...
Anyone had this happen? .. what do you suggest?
Any constructive comments will be appreciated.
Malrik - Master WS- Ahazi
That happened to me once, i FLIPPED, it was a run of 8 BPH's too.
They appeared later on
i get this with terminal results (no item ever) when my factory output hopper is over half full... i get a blank email from the factory telling me of an error though...
output hopper is at 70 items last i checked...
does it just burn what you are making? or will it appear when i empty it out some?