Weaponsmith Archive
Thread: Custom Carbine Question
Page 1 of 1
ElvisTheKing
Thu Jun 02, 2005 11:59 am
#1
Hello All,
I find that low sac weapons give me the most bang for my buck. But, these weapons still need to do a fair amount of damage. I have read that the minimum SAC on a carbine is 73. Was that 73 reached with a stock? What is the lowest you can get without a stock?
I would like to have a customElite carbine made. I haveKrayt tissues and a Form Fitted Stock. I need to know if I am better off using a crafted stock or the form fitted stock. I would seem that the additional speed and damage of the FF stock has a point where it is valuable. Of course I could be wrong, but I figured I'd ask here.
Thanks,
Eawet
Talset11
Thu Jun 02, 2005 2:11 pm
#2
A bit of a trade off between the two stocks, form fitted will give you more damage and make the weapon faster but no SAC benifit, The hand made will make the weapon less action intensive, slower and no damage benifit.
CorenLanra
Thu Jun 02, 2005 8:26 pm
#3
I have done a run of Elites using Pre-CU Barrel & ABPH + a Post-CU Stock (+1.05 spd -23SAC) to make a nice set of 73SAC Elites, I think max was 887 or something like that and I could use some new polonium Iron (dang new max cap experimenations% made my #1 iron my #10).
samijx
Fri Jun 03, 2005 12:04 am
#4
I've gotten a SAC in the low 60's by using a power-up. It just so happens to be on my Elite Carbine. I think my SAC on it is like 75 or so (Decent damage numbers when compared to any of my carbines other than my proton carb.) Then with the power-up I get my SAC to about 63 (I think). I can spam specials and watch my green bar grow simultaniously. The DPS is a lot less than my Proton with a damage PUP, but together they make a great pair of carbines!
Page 1 of 1