Weaponsmith Archive
Thread: Is a set of 165 dmg power cells usually good enough to double cap?
I'd say, SAC cap the ABPHs, give rest to speed, then SAC cap the APRBs, give rest to speed. The stock should be SAC capped (unlike while using a stack of 180+ power cells) and the rest put into speed again.
If bespin ports help and resources are good, I think you wouldn't be needing to spend too much experimentation points on the SAC reduction to cap it at 82, and you could put the rest into damage toget it close to the cap. But yes, you might need a 1000 base damage post assembly.
But yes, it would be a tad slower, but not too slow. -22 SAC on the stock with a speed addition, or -12 SAC or so with speed reduction? The choice is yours. You can always go for a full speed slice, or a 1/2 speed slice + the rest into critical slice (for HLRs of course, since you're a BH anyway I'm assuming).
That's just my 2 cents.
Message Edited by spincrus on 09-29-2005 08:25 PM