Tailor Archive

I wanted to start using some nifty set-up macros to help with grinding to Master, but seem to be having problems with the suggested macros on this board.

Has anyone successfully used macros for crafting in the past week or so?

If so, I know it's a pain to re-post them, but can you give me the commands that you are using successfully?

I'm

Argh!.. Hit the wrong key.
Well, I was just going to say I'm sure it will help more then a few wrist tired grinders out there if you do.

Thanks in advance!

if you are trying to do the tool bar click, then yea it still works.

you need something like this:

/ui action toolbarSlot00;/selectdraftschematic 56;

Your toolbar starts at 00 and goes to 23. If it is a single digit number, it needs the leading 0. The command is CASE sensitive so the S in Slot must be upper case. /selectdraftschematic will select ribbed shirts or cartridge belts. 56 is the number of my ribbed shirt schematic, you will need to play around with this number depending on which schematics you received first.

Make that your macro, put a crafting tool in the first slot in your toolbar and then run the macro. It should open up the tool and select ribbed shirt.

Heheheh wow..... and I still do it the old fasioned way.... by actualy sitting down and working.... but I digress..... Ignore my bitter traditionalistism.....

Kael'thulas

I just did a quick search and found a link to this site. Did a quick check and the info seems to be good. Other macros listed there as well.

http://www.geocities.com/darkimitation/swgmacro.html