Pistoleer Archive
Thread: pvp armor for a pistoleer
Get composite only. Then you need to do the following:
1. Get a full suit with low 70% base and hope for slices to get you to 90% resists. Make sure it has resists to everything but stun. Special resists will not be effected by slices...you should hope for Acid and Heat resists over 80% at the very minimum. On Bloodfin, these will run about 80-120K a piece...and you may need a few of each pieces to get a slice over 80%.
2. At minimum, buy a stun resistant helm. If you can, buy a full suit. Overall resists will be less than normal composite, and hope you can get the stun resists in the mid to high 30%. 70-80% on other resists after slice are good. These cost more....the helmet is the most important to avoid BH's, Fencers, and Riflemen.
3. Get some PSG's with resists to stun. The are bugged so that everytime you cross a server boundary they stop working, so reequip them often.
SithSaberMaster wrote:
If you are serious about pvp, like the others stated stun composite is THE only way to go........ this game reminds me of lemmings because it has absolutely no variety.![]()
Yes, there should be more penalty to wear highly armored suit. Like walking slower, firing slower ...
Current encumbrance system is broken because of all the buff and the composite armor ("one armor to rule them all").
I would have prefered armors which have one high resist and low on the rest (like ubese).
MCPrimetime wrote:
Get composite only. Then you need to do the following:
1. Get a full suit with low 70% base and hope for slices to get you to 90% resists. Make sure it has resists to everything but stun. Special resists will not be effected by slices...you should hope for Acid and Heat resists over 80% at the very minimum. On Bloodfin, these will run about 80-120K a piece...and you may need a few of each pieces to get a slice over 80%.
2. At minimum, buy a stun resistant helm. If you can, buy a full suit. Overall resists will be less than normal composite, and hope you can get the stun resists in the mid to high 30%. 70-80% on other resists after slice are good. These cost more....the helmet is the most important to avoid BH's, Fencers, and Riflemen.
3. Get some PSG's with resists to stun. The are bugged so that everytime you cross a server boundary they stop working, so reequip them often.
If you get lucky, you can find pre nerf armor over 90%, but it will be pricey on any server.
/agree with everything he says . however if you do not have novice medic then i would strongly recommend getting an entire suit with a light stun layer , even a 4% stun layer cuts the damage from a geo blaster or a stun baton into half . either way as mentioned above you want to get atleast a 30% stun layer on your helmet .
oahep acto