Pilot Archive
Thread: Droid Programs, have I missed something?
Page 1 of 1
DarkZenith
Wed Jul 20, 2005 1:11 am
#1
Just a quickie. Is there anyway to tell which droid programs I have running? Obviuosly you can tell Eng andCap (maybe sheilds but I never run Reb commands) but is the a command that will tell you what you have running? And if not why not!!! You could class them as buffs so why not the pretty little icons post CU seem to love to much.
Thanks
DZ.
OrizCore
Wed Jul 20, 2005 1:19 am
#2
A good question. Sometimes after i repair certain overloads arent giong anymore and some are, a way to indicate what level of what overload was going on.
HewerofWood
Wed Jul 20, 2005 4:51 am
#3
Engine Overloads are reflected in your actual speed. If you know what Engine you have equiped, then, when at max speed, a glance is all you need to tell you if that Command is up and running.
You can see if Weapon Cap Overload is running by looking at your ship display panel. Check what your recharge rate is at. Again, you have to know what Capacitor you have installed.
I'm not sure about reactor Overload, as I haven't had to use this one for quite some time.
The weapon Overloads don't show. And, I haven't bothered with ANY of my rebel commands in a great while.
Attacca
Wed Jul 20, 2005 8:51 am
#4
Some overloads who on your ship stats screen, although I'm not sure which ones. I know cap overcharge does.
I always, always run the same programs in the same order, so I can remember what I've done. They'll also show up in the spatial window.
Page 1 of 1