Pilot Archive
Thread: Droid and computer commands
Page 1 of 1
Dixos
Thu Jun 23, 2005 4:44 am
#1
Hi
Im a 4433 reb pilot and it takes my droid about 120 seconds between commands like overload 3 etc. How can I make this faster - do I look for a droid interface with the highest speed value?
Matheaue
Thu Jun 23, 2005 4:51 am
#3
To my understanding, the time it takes between each command is the speed of the droid interface component multiplied by the level of the command. Lower is better for that stat.
Favos
Thu Jun 23, 2005 5:23 am
#5
Matheaue wrote:
To my understanding, the time it takes between each command is the speed of the droid interface component multiplied by the level of the command. Lower is better for that stat.
i dont know what is correct.. but i know this is not correct 
i can use my capa to shield shunt 3 and 4 after the same time again. no difference if its the 3 or 4
the reset commands are in same speed as the shield shunt.
only the overcharge commands use lot more till i can use another command..
i am not sure but it could be that the shieldshunt and reset commands are exactly the time your DI indicates..
Goraf
Thu Jun 23, 2005 5:24 am
#6
What is your level, speed, and mass of your droid interface Dixos?
maxsmelling
Thu Jun 23, 2005 5:27 am
#7
just hyper, it resets the interface. and yes, lower is better. but who cares, just hyper.
Page 1 of 1