Pilot Archive
Thread: Macros to run droid programs
Page 1 of 1
Ralen-Sharr
Fri Sep 30, 2005 5:04 am
#1
I used to run a macro that would fire off my droid programs, and then it just stopped working.
now the only way I can do my droid programs is either from the menu or the toolbar
did the / command change for droid commands?
now the only way I can do my droid programs is either from the menu or the toolbar
did the / command change for droid commands?
CNevyn
Fri Sep 30, 2005 10:44 am
#2
I haven't had any problems with mine, ran them several times last night.
With the GUI glitches, you might re-check your macros; aliases if you've assigned them to macros, verify the levels, droid/flight comp.. (done any component shifts lately? DI? Booster?)
All I can think of..
Ralen-Sharr
Mon Oct 03, 2005 4:34 am
#3
ok, got most of them working
can't seem to get cap overload going though, anyone know the /droid droidcommand_??? for cap overload?
can't seem to get cap overload going though, anyone know the /droid droidcommand_??? for cap overload?
S-1-l2-H-C
Mon Oct 03, 2005 5:51 am
#4
Ralen-Sharr wrote:
ok, got most of them working
can't seem to get cap overload going though, anyone know the /droid droidcommand_??? for cap overload?
/droid droidcommand_weapcappowerupfour
Catman-Does
Mon Oct 03, 2005 6:20 am
#5
I tried to do a "power up ship" macro which would load all the commands in the correct sequence. However I found that I was having to set the /pause a good few seconds after the droid should be able to run another command - and this seemed to get extended by another few seconds after hyperspacing. Annoyed me a bit
Page 1 of 1