Pilot Archive
Thread: Is this good for a jsf setup
Page 1 of 1
sickboy_ukuk
Tue Jun 14, 2005 4:58 pm
#1
i just got 4/4/3/3 on pilot and setup my Jedi Starfighter with the following components.
reactor:
mass 6707
gen rate 12387.5
engine:
mass 13478
pitch 61
y 59
r 57
total speed 102.3
shield:
mass 15246
front hitpoints 980/1238
rear hitpoints " / "
armor x2:
mass 8705
hitpoints 843/843
armor 804/804
capacitor:
mass 4798
energy 512/848
recharge rae 36.8
weapon x2:
mas 14584
damage 1480/2894
refire rate 0.350
let me know if it needs any tweekking
ZinaTheMaker
Tue Jun 14, 2005 5:02 pm
#2
reactor is probably too heavy. u can do a lot better for less mass. armor maybe too heavy, and sheilds u may consider a nice RE'd reward shield.
OvMan32
Tue Jun 14, 2005 6:28 pm
#3
Yea as he said. You can get the same gen rate with a reactor that has around 3-4k. Also, the sheilds could be a slight better. i was able to fit in 1900hp sehilds in mine, with full armor/interface. not sure on mass tho
iansarria
Tue Jun 14, 2005 6:40 pm
#4
sickboy_ukuk wrote:
i just got 4/4/3/3 on pilot and setup my Jedi Starfighter with the following components.
reactor:
mass 6707
gen rate 12387.5
engine:
mass 13478
pitch 61
y 59
r 57
total speed 102.3
shield:
mass 15246
front hitpoints 980/1238
rear hitpoints " / "
armor x2:
mass 8705
hitpoints 843/843
armor 804/804
capacitor:
mass 4798
energy 512/848
recharge rae 36.8
weapon x2:
mas 14584
damage 1480/2894
refire rate 0.350
let me know if it needs any tweekking
armor x2:
mass 5200
armor1050/1050
i craft some like this for my jedi sf
but i use a 8000 mass 14500 energy reactor to use all my overload programs
and use a low mass cap and booster rev eng
Page 1 of 1