Pilot Archive
Thread: Project Shoehorn: The Bel from ****
Page 1 of 1
Kebb
Wed Oct 19, 2005 10:09 pm
#1
For a while I've been attempting to fit a QID, Lvl 8 shield, Lvl8 gun, Lvl7 gun and a workable booster into my Bel-22. In order to be successful, It would have to be able to run EO4/WO3. I was able to fit everything in,but could only run EO3/WO3 due to the small reactor. Now that Pub24 fixed the drain bonus, I finally got my Ion Pulse weapon RE'd. This freed up enough mass to load a beefier reactor and allows for EO4/WO3. I haven't tested it yet, but I'm pretty sure I've got enough power left for a CO as well. I also think I can get a chaff launcher in with just a bit more tweaking. Here's the specs:
Reactor
Lvl 1 crafted
Mass: 1269
Energy: 12302
Lvl 1 crafted
Mass: 1269
Energy: 12302
Engine
Quantum Ion Drive (lvl 8)
Drain: 1488
Mass: 21502
P: 76.1
Y: 75.8
R: 75.5
SPD: 105.2
(I know, shoulda held out for better YPR/drain. Still kicks butt.)
Drain: 1488
Mass: 21502
P: 76.1
Y: 75.8
R: 75.5
SPD: 105.2
(I know, shoulda held out for better YPR/drain. Still kicks butt.)
Shield
Lvl 8 reward shield
Drain: 2022
Mass: 24726
F/B: 2555/2555
Recharge: 14.50
(This is my original Armek that got RE'd many months ago.)
Lvl 8 reward shield
Drain: 2022
Mass: 24726
F/B: 2555/2555
Recharge: 14.50
(This is my original Armek that got RE'd many months ago.)
Capacitor
Lvl 1 crafted
Drain: 883
Mass: 984
Energy: 592
Recharge: 32.9
Lvl 1 crafted
Drain: 883
Mass: 984
Energy: 592
Recharge: 32.9
Booster
Lvl 1 crafted
Drain: 583
Mass: 689
Energy: 844
Recharge: 21.6
Consumption: 115
Accel: 25.1
Speed: 27.7
Lvl 1 crafted
Drain: 583
Mass: 689
Energy: 844
Recharge: 21.6
Consumption: 115
Accel: 25.1
Speed: 27.7
Droid Interface
Pre-nerf lvl 1
Drain: 492
Mass: 505
Speed: 14.7
Pre-nerf lvl 1
Drain: 492
Mass: 505
Speed: 14.7
Weapon 1
Ion Pulse Weapon
Drain: 1758
Mass: 13944
Damage: 2095-3071
Vs. S: .660
Vs. A: .650
EPS: 20.2
Refire: .300
Ion Pulse Weapon
Drain: 1758
Mass: 13944
Damage: 2095-3071
Vs. S: .660
Vs. A: .650
EPS: 20.2
Refire: .300
Weapon 2
Borstel Disruptor
Drain: 1918
Mass: 25653
Damage: 2507-3876
Vs. S: .670
Vs. A: .690
EPS: 13.4
Refire: .390
(Like the shields, this was RE'd ages ago)
Borstel Disruptor
Drain: 1918
Mass: 25653
Damage: 2507-3876
Vs. S: .670
Vs. A: .690
EPS: 13.4
Refire: .390
(Like the shields, this was RE'd ages ago)
Total mass: 89275/90000
Total energy: 9148/12302
Total energy: 9148/12302
EDIT- FWIW, just take out the Borstel and this becomes a viable A-wing setup.
Message Edited by Kebb on 10-19-2005 10:16 PM
Julak
Wed Oct 19, 2005 10:13 pm
#2
Only thing i cna think of is the capacitor, i have one that is about 800 and gives off aobut 900 energy. Now all sorts of pilots are gonna post here and i cna garuntee that they will tell you that you can tweak everything to have lower mass, just dont take it as criticism, i jsut think that if it works for you, dont sweat it, it not like mass affects your YPR.
Kebb
Wed Oct 19, 2005 10:28 pm
#3
No prob. I welcome the suggestions. Do you recall the drain and recharge on thecap you mentioned?
Julak
Wed Oct 19, 2005 10:57 pm
#4
yea i jsut cheked, she is 894 mass, 1100 drain, 818 energy, with 37 recharge. its interesting as i use a reactor with 12k energy and i usually have 1-2k to psare, but then agin i only have one gun. oh yea, good mass on your lvl 8 shiled, its awesome to me.
evil_SOCCERMOM
Wed Oct 19, 2005 10:57 pm
#5
This might be a stupid question, but I noticed that you mentioned running weapon and engine overloads (and a desire to overload your capaciter) and I wondered if you knew you could overload your reactor as well because running reactor overload four I have enough energy to run EO4/WO3/CO4 on a fully loaded krayt and a 13k reactor.
Kebb
Thu Oct 20, 2005 12:24 pm
#6
I had been running RO3/WO3/EO3 in that order. With my previous reactor and high drain on the non-RE'd Ion Pulse, even RO4 wouldn't let me run WO3/EO4. Of course it has been a while and there may be a couple components that have been traded for ones with less drain, so I'll have to do a bit more testing.
EfreaK
Thu Oct 20, 2005 12:57 pm
#7
Possible changes I see.
Replace the Level 8 shield with the ROTW Level 7 shields.
Replace the Level 8 shield with the ROTW Level 7 shields.
The shield I use is 2200 Front/Back at 13.6k mass.
With the freed up mass, you can add a Mk2 Im-rec and a RE Level4 cap.
Should easily get 42+ recharge and 1100 stored energy pre-RE. Mass around 2.5-2.8k
Should easily get 42+ recharge and 1100 stored energy pre-RE. Mass around 2.5-2.8k
And room for a bigger reactors. Crafted lvl 5 or 7.
Page 1 of 1