Game Guides Archive

Here is my experience with the first force sensitive crafting quest. You will need to complete this quest tounlock the first crafting branch which is assembly.

( I just completed it today and since there is not much written about it yet I thought I would submit what I could for once.)

Its not that hard but what I can tell you may speed it up a little.

Go to Quharek.

He is located to the back and right of the front gate entrance to the village. He asks you to help repair the solar array. (or something like that) It is located at the far back wall directly in line with Paemos.

(Since Paemos is the first person you need to find and visit when you get there I assume everyonewill know who he is by the time they look up and findthis submission).

At the array: go to the terminal in front of it and look inside it. There will be components you can remove. Remove them all.

Go to the Component Hut: at wp 5375 -4116 (Dath)(it is right there near the array)

Inside you will find an analyzer and a calibrator on the back table. The analyzer will deconstruct the components and load the schematics to your general or weapons and general crafting tool. After the components have been made they will need to be calibrated. On the calibrator (next to the analyzer) there is a different calibration screen for each component. They are all self explanitory and easily calibrated except for the last one. The solid state array is tricky so go to the village with enough extra resources to try several times. It took me 5 (with a couple off planet trips for more resources)tries to get it. The village is >5k from the science outpost on Dathomir, so this increased the time it took (after gathering the yavin wind, and the naboo water which I didnt have on hand) by almost an hour.

Components &schematics:

Configuration Processor- 50 rori fiberplast/45 copper/40 aluminum

Gyroscopic reciever- 50 yavinian wind power/20 lub oil/45 steel/20 copper

Signal Ampliphier- 70 copper/20 carbonate ore/25 talusian fiberplast/20 aluminum

Solid state array-100 extrusive/10 naboo water/20 polymer/10 copper

On calibrating the solid state array: On the try that was successfull, I refrained from totally aligning

any of the rods untill all of them were at the almost aligned stage. Then it all worked. I don't think there was any particular order in which they needed to be aligned, because I began by trying different alignment orders.

One last note: all the schematics get deleted from your data pad after using them once. However, you can go back to the analyzer and 'load from memory' any of the schematics that you need to do over. There are two button choices on the analyzer. Deconstruct component, and Load from memory.

I hope this helps all those crafters who, like me get all goose bumpy when that message comes up:

"You have unlocked force sensitve Crafting Mastery level 1: Assembly: dextrous touch