Droid Engineer Archive
Thread: What is the simplest storage droid?
Page 1 of 1
ranger_one
Sat Jun 12, 2004 1:09 am
#1
A newb DE here.
Was wondering would this be one of the easiest item storage droids (10 storage capacity) to make?
1x Adv MSE chasis
2x Lv 4 Item Storage Modules
Is that right? Can any1 suggest a better solution? Or find a flaw in the above configuration?
Thanks.
Was wondering would this be one of the easiest item storage droids (10 storage capacity) to make?
1x Adv MSE chasis
2x Lv 4 Item Storage Modules
Is that right? Can any1 suggest a better solution? Or find a flaw in the above configuration?
Thanks.
Asteroids
Sat Jun 12, 2004 3:29 am
#2
Thats probably about right if thats the resources you have available.
I prefer to do the standard mse's with a level 6 installed.
Kellisanth
Sat Jun 12, 2004 9:41 am
#3
Assuming you do not have Lidium (rare beast that spawns once every 5 centuries) ... Then your only option will be to make the Adv MSE and use two L4 modules.
If you are lucky enough to have a large stash of Lidium, then yeah... Stick with the normal MSE.
When possible, check with other DE's or resource vendors... Maybe they might spare or have some lidium for sale. Just be aware for possible sticker shock!
HFrankenstein
Sun Jun 13, 2004 4:12 pm
#4
Actually, I use a lvl3 and a lvl4 module. Same effect, and you don't use as much of your precious extrusive ore. I'm not sure if you need to dump in a lot of experimentation points, but it can't hurt. Anyone know for sure, though?
Wirebiter
Sun Jun 13, 2004 4:40 pm
#5
yeah, 2 level 4's is over-kill
You can use a level 3 and level 4 and get the same results. Heck, you can use 2 level 3's as long as you experiment them up to a 6 (storage capacity,i think)effectiveness on each module. The total of the two modules just has to equal 12 for it to have thesame capacity as a level 6 storage module.
This is myunderstanding on the subject.
CHODA----MDE/Droid teacher to the Kettemoor massess
Page 1 of 1