Droid Engineer Archive
Thread: Droid armor module 6 composite armor segment
Page 1 of 1
HRRNighthawk
Wed Feb 23, 2005 9:33 am
#1
alright, well i'm getting to the point where i'm just doing large runs of each type of droid and getting together the materials i need for others. So i'm looking at the possibility of combat droids and while i've got the good materials now for auto-repair modules i don't have a way to make the composite armor segments needed for level 6 armor modules. My questions are thus:
1) Is there even a reason to make lvl 6s...or will 2 stacked lvl 4s have the same effect?
2) For the chassis that accept 2 defensive modules...will 2 lvl 6 modules stack to make a greater effect (don't think so but making sure).
3) I'm assuming most MDEs don't have the armorsmith lines just to make composite armor segments (requires 4-0-0-0) so how much do you pay an armorsmith to make the blueprint with your materials?
Thanks!
Helstrum
Wed Feb 23, 2005 9:46 am
#2
1. I think two level 3's will do the same as a level 6 as long as both or Quality > 50%
2. One level 6 maxes out the armor
3. Make a friend with an armorsmith. They'll make the schematic for free then if you supply the resources.
2. One level 6 maxes out the armor
3. Make a friend with an armorsmith. They'll make the schematic for free then if you supply the resources.
RasalTheWise
Thu Feb 24, 2005 1:00 am
#3
And always a good point to make about composite armor segments for our droid armor modules: Quality doesn't matter in the least. Have the AS make you the most basic CAS with the crappiest resources. Make it cheap cheap cheap. 
Page 1 of 1