Droid Engineer Archive

Thread: Question on the looping macro...

JStretch
Fri Nov 28, 2003 7:41 am
#1
OK, so I've used the macro so far to get 0-0-1-3 in DE and now I'm having trouble because when I go to change the number of the Draft Schematic in the macro, the schematic changes up until 130, then if i put the number higher than that, it stays the same schematic as 130 is.... the problem is that the schematic i need is past 130, is there anyway to get past this or is this as high as the game allows you to put it?



- I support the New Game Enhancements (NGE), and you should too!
"You understand that we may update or otherwise enhance the Game and/or the Software at any time and in doing so incur no obligation to furnish such updates to you pursuant to this Agreement. You understand that online games evolve over time and, accordingly, system requirements to play the Game may change over time."
Zoppo
Fri Nov 28, 2003 8:03 am
#2
Afaik the schematics are grouped and the gap to the next group is filled with the last schematic in the last group.
So for instance if there are groups of 20 and the last schematic you actually have in the 120-140 group is the one at number 130, it will stay the same until 140. I suggest you increase the schematics number in steps by 5 and check, if you reached a new group.

Someone please correct me if I´m wrong.



Daktari, Master Droid Engineer on Lowca
Zoppo
Fri Nov 28, 2003 8:04 am
#3
Oh, and btw, 130 is not the highest schematic number.



Daktari, Master Droid Engineer on Lowca
Page 1 of 1
Previous Next