Droid Engineer Archive
Thread: Total ammount of resources for Master DE?
I think it would take about 400k steel + around 270k fiberplast.
Been a while since I've had to think about it...
It was round 1.25mil exp required to master
ok, did some calculations
Steel: 450k
Fiberplast: 210k
That should be about accurate
Just for clarification: That is presuming 5% chance of criticals and including the 10% bonus for
Message Edited by Droid_Engineer_Rho on 02-20-2004 02:10 PM
Once you have advanced droid blueprints and can make the advanced frame, you need 1,113,600 more droid experience points to hit master.
An advanced droid frame gives 460 experience points,483 in practice mode, and takes 150 units of steel and 70 units of fiberplast to make.
You need to craft 2306 advanced drod frames in practice mode to get the experience needed.
This means you wil burn 345,900 units of steel, and 161,420 units of fiberplact after you hit advanced droid blueprints.
Message Edited by Sketh on 02-20-2004 01:18 PM
Ogge_the_Lizard wrote:
Hmm, well... I was calculating at a bit higher xp levels so it should make up for the crit fails.
Good point - this is the absolute minimum that I posted.
Probably adding around 10% or so to what I listed would give a more realistic number.
Sketh wrote:
An advanced droid frame gives 460 experience points,483 in practice mode, and takes 150 units of steel and 70 units of fiberplast to make.
Message Edited by Kollos on 02-20-2004 11:10 AM
Droid_Engineer_Rho wrote:
Ogge,
Just for clarification: That is presuming 5% chance of criticals and including the 10% bonus for experimentation?
Unless something has changed, there is noXP bonus for experimentation.
Kollos wrote:
Correction: The Advanced Droid Frame Unit gives 440experience and 462 in practice mode. (150 steel + 70 fiberplast = 220 resources.)
This is not correct. If you use the schematic and do the math, or go to swgcraft.com, you will find that it is a base of 460 exp.
It is not 2 exp per resource unit used.