Droid Engineer Archive
Thread: Programming Flight Comp/Astromech
Page 1 of 1
Yiddo-Chimaera
Fri Oct 14, 2005 5:40 am
#1
Hi all
I mastered DE quite a while ago but have been spending alot of time piloting of late with rebel, imp and freelance so have subsequently done alot of chip programming.
Anyway I've sorta been experimenting and came up with a problem when transferring the chip program to the flight computer or astromech. The first time it's programmed it all goes in fine but when you try adding chips afterwards, or non-chip programs, then it doesn't save the changes.
This is frustrating but not too bad as funnily enough I have the resources to just make new flight comps/astro's but I shouldn't have to.
Is this a known problem?
Rgds
Jenden
Fri Oct 14, 2005 6:48 am
#2
Make sure you're hitting all the right confirmation buttons and not accidentally cancel. I've not had this problem before.
Yiddo-Chimaera
Fri Oct 14, 2005 7:14 am
#3
I have tried with all 3 characters and definately happens everytime. The initial programming works fine it's just when I try re-programming with extra chips is the most common cause.
As I said not a major inconvenience for me but would like to know if anyone else has seen the problem. If you've not seen it is there anything I can (screenshots, tickets) that can help ascertain what's going on?
Regards
Straker_Atrella
Fri Oct 14, 2005 7:50 am
#4
You need to to remember to save it after you move it over. I had that happen a few times before I realised I was missing a button. I can't tell you the exact process since I'm at work, but check on the bottom.
Yiddo-Chimaera
Fri Oct 14, 2005 4:20 pm
#5
pretty certain I 'committed' before saving but been a while since I reied last.
Will play and c what happens ....
Page 1 of 1