Doctor Archive
Thread: Problem with Schematic Switches?
Page 1 of 1
kt2000tx
Sun Mar 06, 2005 5:25 pm
#1
I had to reset my craft macro on my TKM-Doc character today since I've been away awhile...for some reason the macro I had before didn't save.
Anyway, I went through the schematic numbers through trial and error until I found the ABEC finally. I run a test macro...ABEC comes up as it should. I go a second time just to make sure, and it's not the ABEC anymore. I didn't change a thing in between. Has this happened to anyone else?
I wish there was a more straightforward way to set the macro up for a schematic. It's hard to pinpoint the one you need when you have a ton of schematics.
I was just curious to see if anyone else had the schematics seemingly switch on them number wise.
Anyway, I went through the schematic numbers through trial and error until I found the ABEC finally. I run a test macro...ABEC comes up as it should. I go a second time just to make sure, and it's not the ABEC anymore. I didn't change a thing in between. Has this happened to anyone else?
I wish there was a more straightforward way to set the macro up for a schematic. It's hard to pinpoint the one you need when you have a ton of schematics.
I was just curious to see if anyone else had the schematics seemingly switch on them number wise.
Message Edited by kt2000tx on 03-06-2005 06:25 PM
Obata
Sun Mar 06, 2005 5:30 pm
#2
Instead of putting the schematic number in the macro, just use '/ui action defaultButton'. With that line, all you have to do is start a crafting tool and select the ABEC manually for the first one. Then run the macro. The tools retain the last selected schematic.
swashblucker
Sun Mar 06, 2005 5:34 pm
#4
when i grinded i had huge problems finding the right schematic number..so i changed the /selectdraftschematic ## to /nextcraftingstage and just made 1 run manually,after the run the crafting tool automatically selects the schematic you used.
worked very well for me.
worked very well for me.
Page 1 of 1