Doctor Archive
Thread: Enhance D's and Experimentation
Page 1 of 1
Brainhammer
Mon Nov 22, 2004 9:06 am
#1
Can someone please tell me what is the most effective way to spend my experimentation points on Enhance D's?
I am experimenting on the Effectiveness line. 1 point at a time? 2 points? Please help.
All input is welcome.
Thanks,
Drallasa Ofek (Master Doctor on Flurry)
Lihpson
Mon Nov 22, 2004 9:30 am
#2
I dont think it really matters. I always did 2-4 pts at a time. Just make sure you get at least Great Successes and you should be fine.
nerf_you
Mon Nov 22, 2004 9:49 am
#3
While making schematics I use as many points as possible. This reduces the complexity and hence the amount of time it takes in the factory.
If I'm crafting something like janta buffs or similar where I can't afford a crit fail, I do 1-2 points at a time.
Visnja
Mon Nov 22, 2004 4:33 pm
#4
I go with 3-4 points at a time and usually take bespin port right before I experiment to get a "great success" or higher. Only once have I had a critical failure while using bespin port. That was because I took too long experimenting, trying to decide where to start first .. *sigh*
warrior1
Tue Nov 23, 2004 11:17 am
#5
go 4,2,2 and you will use 1 less point on experimentation, instead of going 1 at a time.
try it both ways and you will see the difference.
Brainhammer
Tue Nov 23, 2004 2:28 pm
#6
Thanks for all of the suggestions, they are much appreciated.
Drallasa Ofek (Master Doctor - Flurry)
Chachoui
Wed Nov 24, 2004 2:03 am
#7
I alwaysmax out on xp, so you have less chance of an failure and if you get an amazing you get that extra point to experiment with.. saves you time as well
Page 1 of 1