Doctor Archive
Thread: 2 ways to tackle factory problem?
From reading this board and swgmedic.com, 2 methods have been suggested to tackle the factory problem:-
1) Priming the crates
2) Moving crates directly from output to input hopper
So which method is better?
I tried priming, i can get sometimes 55+ crates made without interruption. gonna try method 2 tonite. are these the correct steps to take for method 2? -
1) Make schematics of BEC, CDRM and LS for 1000creations.
2) Load the BEC schematic, shove 1230organics/1230inorganics into the input hopper (gonna try to get 205BECs in 5crates). After its done, do the same for CDRM (1640org/inorg) and LS(1230org/inorg).
3) I should get 5crates of each component by the end of this.SoI'll takeout the 3crates of5components.
4) Make aschematicfor StimB for 1000creations.
5) Shove in 2400org/inorg (200x12). Move the component crates from output hopper to input hopper directly, using the same sequence in List of ingredients. (Close ya inventory just in case)
Anyone tried theabove exact steps and it didn't work?
)
Is it possible for the factory to produce items from multiple schematics? What I mean is.... If i want to create a crate of BEC's and then a crate of Solid Deliver Shells, can i load both schematics and all required resources into the hoppers and just tell it to start? Will it finish one run and begin to start on a different one? Thanks!
JNope. One schematic at a time only.
You'd need two factories to use two schematics.