Commando Archive
Thread: About FlameSingle2
Hi all,
Which flamethrowers you would use to stick FlameSingle2? A speed sliced one or a damage sliced one? Please give me advice.
Thx.
8.5 seconds? what you on about?
For single flame go speed becuase.. If you were to say spam Single II, the time waited between each attack is the attack speed of your gun. At Flamer IV, the speed skill mods are that good that with my 3.2 speed flamer i fire every 2 seconds, and with my 4.7 i fire every 3 seconds, but, the specials remain the same, 3.2 seconds between each single, and 4.7 between each single on my other one..
8.5 Seconds is a loud of rubbish, unless his flamer is 8.5 second speed!
8.5 seconds? what you on about?
For single flame go speed becuase.. If you were to say spam Single II, the time waited between each attack is the attack speed of your gun. At Flamer IV, the speed skill mods are that good that with my 3.2 speed flamer i fire every 2 seconds, and with my 4.7 i fire every 3 seconds, but, the specials remain the same, 3.2 seconds between each single, and 4.7 between each single on my other one..
8.5 Seconds is a loud of rubbish, unless his flamer is 8.5 second speed!
what a nice lier
no matter what flamer you use delay after speciles is always 8.5 (unlessyou have a reall slow one or stund in that case its slower)
this fact has ben tested and retested and has ben proven NO FLAME THROWER CAN SPAM FLAME SINGL 2 EVRY 2 SECS ITS ALWAYS 8.5 SEC (unlessyou have a reall slow one or stund in that case its slower)
now a llc on the othere hand can do that i have logs a a llc doing that but thats a bh wepon not a commando wep
firstly my specials never take 8.5secs delay.. my flamer is 3.3 speed and i can guarantee its less than 8 secs between single or cone spam
just the thing with dm sliced ones.. isnt the dot much bigger then too.. so a dm sliced would be better against high heat res monsters that u kill with dot basically