Chef Archive
Thread: Light Bio Food Coponent, what and where ?
Page 1 of 1
outdr724
Fri Oct 22, 2004 9:34 am
#1
Iam new to Bio Engineer and Chef so when the food asks for a Light food additive and an ingrediant to make the Light food additive isa Light Food Bio Component I wanna make one. I am a Master Bio Engineer and Master chef, but I cant make it. I am very confused, some foods want a medium or heavy food additive which both require a medium or heavy bio food component, but who makes these, Bio Engineer ? Chef ? or something else, I cant find it in any prof's craftable list
I also posted this question in the BE forum, Im desperate for answers
OditeFosore
Fri Oct 22, 2004 9:41 am
#2
Bioengineer products are mixed with water in a factory run to make chef food additives:
- Micronutrient Supplement becomes Light Food Additive after a factory run with 10 water per unit
- Broad Spectrum Nutrient becomes Medium Food Additive after a factory run with 15 water per unit
- Intelligent Nanonutrient becomes Heavy Food Additive after a factory run with 20 water per unit
Look for Micronutrient Supplement (MSN),Broad Spectrum Nutrient (BSN), andIntelligent Nanonutrient (INN) schematics in the Bioengineer tables and look for light, medium, and heavy food additive in the chef tables.
outdr724
Fri Oct 22, 2004 9:56 am
#3
/confusion
So I make a micro nutrient supplement schematic and then when I put the schematic in the factory I put water in there too and what is made will be a light food additive? It does it on its own ? Im slightly confused
sciguyCO
Fri Oct 22, 2004 10:18 am
#4
outdr724 wrote:
/confusion
So I make a micro nutrient supplement schematic and then when I put the schematic in the factory I put water in there too and what is made will be a light food additive? It does it on its own ? Im slightly confused
Not surprising, it's a confusing system.
1) As a BE, make a MNS schematic. Run this through your factory to get crates of MNSs.
2) As a chef, make a light additive, using one of the previously manufactured MNS as the bio component and 10 units of water. The MNS is a component of the additive in the same way that protatos are a component of Bivoli.
3) Put the water and the crates of MNS into the input hopper of the factory, insert the additive schematic, and let it rip.
outdr724
Sat Oct 23, 2004 2:49 am
#5
Thank you Kriles, I'm sure I can figure it out now
The BE forums were flaming me on not knowing what I was doing, Its nice to get help without downing on me.
Page 1 of 1