Bio Engineer Archive
Thread: FAQ crafting macro question
Page 1 of 1
Roycroft
Tue Nov 02, 2004 8:23 pm
#1
As it instructs, I've counted through my schematics and modified it with *my* schem number (175)....and got within one. So I dump it, modify the macros.txt file by onein my swg folder, re load it and it still is trying to make the same schemas if I hadn't edited it.
So I went back and changed the number by 10to 165...and it is STILL trying to load the original schem as if it's not updating my saves.
I /load macros.txt (after saving to correct folder) and it confirms load...tried logging all the way out and back in and no change.
Any helpappreciated.
NancyJ
Tue Nov 02, 2004 11:44 pm
#2
When you put in a number greater than the schematics you have with that tool it will pull up the last schematic in the list.
Are you sure you're only counting the schematics that can be made with the tool you're using?
Also the number will be different depening whether you use a crafting station or not.
Are you sure you're only counting the schematics that can be made with the tool you're using?
Also the number will be different depening whether you use a crafting station or not.
Roycroft
Wed Nov 03, 2004 9:29 am
#3
That's exactly what it is....I was counting every schematic. I'll try again when I get home.
Thank you Nancy 
GMANHNC
Wed Nov 03, 2004 4:46 pm
#4
NancyJ wrote:
When you put in a number greater than the schematics you have with that tool it will pull up the last schematic in the list.
Are you sure you're only counting the schematics that can be made with the tool you're using?
Also the number will be different depening whether you use a crafting station or not.
so that's how that works... I am going to need this for shipwright... thanks SHAFT!
CapricornONE
Thu Nov 04, 2004 12:11 am
#5
the command /sel will take the place of /selectDraftSchematic.. just saves some typing time when trying to find the right schem number
Page 1 of 1