Bio Engineer Archive
Thread: Bugged Schematics Anyone Else?
I've been crafting stims the past couple of days and haven't had any problems. What schematics are you having problems with? and what problem are you having?
Aleskander wrote:
I've been crafting stims the past couple of days and haven't had any problems. What schematics are you having problems with? and what problem are you having?
At the time I was crafting Stims and Comps.
In each case the factory(s) would refuse to start making items.
In each case I went back to my lab and remade the schematic and then it would work.
In every case, I made the schematic and then tried to used it with in the next minute.
Thinking that lag of some kind would corrupt the schematic because it was not fully downloaded to my datapad by the time I tried to use it. Only thing I could think of.
Anyone else?
Ojes wrote:
I've made quite a few (perhaps 20) different med/tissue schematics since the CU went live. I have had no such problems.
From my past experiences, I have had factories quit before making the first item (waits the delay time then you get the "you have run out of resource xxx" email). In those cases, it was because I inadvertently put the wrong type of a particular resource in the input hopper. I have gone to only carrying the resources for the current schematic with me when going out to the factories.
Although I'm not sure about the timing, I think I have used a schematic within 1 minute of making it. Does the factory accept the schematic and let you turn it on, or does it refuse the schematic altogether?
I've made quite a few (perhaps 20) different med/tissue schematics since the CU went live. I have had no such problems.
From my past experiences, I have had factories quit before making the first item (waits the delay time then you get the "you have run out of resource xxx" email). In those cases, it was because I inadvertently put the wrong type of a particular resource in the input hopper. I have gone to only carrying the resources for the current schematic with me when going out to the factories.
Although I'm not sure about the timing, I think I have used a schematic within 1 minute of making it. Does the factory accept the schematic and let you turn it on, or does it refuse the schematic altogether?
AschMhaRhee wrote:
Make sure your factory has power. The spam messages don't always show up and i've had this happen a couple times.. rechecked all the resources and the crate serial numbers and all that stuff.. and after a few tries checked the factory status and bowed my head in shame.
Nope, I checked and all three factories in my case had power and positive maintenance pool.
I did make that mistake the other day though, LOL.