Bio Engineer Archive
Thread: Tailor/chef tissue questions
Page 1 of 1
Shenron
Tue Apr 20, 2004 6:32 am
#1
a) when looking at schematics for tailor tissues. What does the "mod" mean? Some schematics have mod one and two. Other have four and five... what do those refer to?
b) for all tissues in general... if for example a tissue schematic reads 33% oq 33% pe and 33% flavor... is this for all components of a tissue??
I made some Micronutrient supplements today with corn942 FL, 622 PE and 994 oq (put them in organic and flora slot) and carni meat with 460 FL, 491 PE and 948 oq... result after experimentation: nutrition +54
Afterwards i tried again with much better meat: 880 FL, 668 PE and 817 OQ, combined with same corn... and i get exactly same result: nutrition +54
and MS should use the 33% 33% 33%, so normally the better meat should have increased it a bit
I had no experimentation errors: no failures, good success or amazing successes. In both cases I ended up with 79% experimentation result, and 1 experimentation point left (so it was fully experimented on)
notrom
Tue Apr 20, 2004 6:34 am
#2
they will cap out after a certin power kinda like a master doc makin stim a's
oh and the mods meants it can affect 5 things at once i believe
Message Edited by notrom on 04-20-2004 10:36 AM
notrom
Tue Apr 20, 2004 6:42 am
#4
then try using that higher meat with a higher flavor flora with compable other stats, i also do all my crafting in a expermentation city if you are hitting a ceeling @ 75% theres something wrong with your materials if its 33% across the board try to find stuff with 800 - 900 across the stats
differnt stats in the materials afffect differnt things again ill refer to meds buffs in paticular the decay resistance in materials affects how long the buffs last even tho the schematic only says 66% oq 33 % p this i cant be much help here, im just gettin back into be again i droped it all when i got my xmas holos i was a 3 2 4 1 =/ should of finished it then hindsight is a mofo
Message Edited by notrom on 04-20-2004 10:45 AM
Page 1 of 1