CUEmu - Thread Posts

JayceMilam

Sun Apr 25, 2004 8:22 pm

Ok, I am a MBE on Bria and have yet to find a consistent answer on what type of HAM is possible for CL-10. Whenever i try to sell a non-ch with less than 5k ham my customers complain that they have heard of other BE's selling CL-10 with close to 8-9k ham. I looked on these forums and found a recipe that was for CL-10;

Voritor Dasher (vhq)

Hurtoon Pup (aa)

I used this formula to make two templates ... I ended up with Hardiness in the 450-500 range, (since this was my main focus to max out health) I experimented in physique and psych till they were both maxed in hopes of maxing health and minimizing the CL LVL. I then used the templates to make clones with the bantha skin. One turned out CL 26, the other was CL 23 If anyone has any advice I would greatly appreciate it. My ideal goal would be to make non-ch pets on a consistent basis that have at least 8k ham. All other stats can be minimal. Again I am looking for a consistent recipe, type of dna where to spend my experiment points and how much to experiment.

Play with HONOR

AlufNull

Sun Apr 25, 2004 8:38 pm

#2

Pets of that level are going to get nerfed as soon as the devs figure out a way to do it reliably.

However, if you are determined, all you really need to do is use high hardiness single resist pets in slots one and two, somthing really small inslot three and some average level pets (with the specials you want) in 4+5. You can get pets like this down as low as 12 in one generation. You will need to resample that pet to get the level 10 you want.

That should cover it.

I am nota fan of spoon feeding info, so if you can't work out the details, don't ask me.

"Stop thinking with your flame thrower!" - Bobbi Sox (Master Dabbler), Tarquinas
Tira-Misu Master Gunfighter / Master Bio Engineer (Retired)

SomeUser

Sun Apr 25, 2004 11:29 pm

#3

JayceMilam,

As far as what is possible, 10k health ham with 59% kinetic and 120damage is what what CL10 can be.

I had boycotted making these for a long time and I still wont sell them to the public but I am making a few for friends.

The dasher/pup combo is what I usually use for the public. 3.8k/2k/1.5k hams with 60ish damage and 14% kinetic is what I usually get outa them.

Vezek

SomeUser

Sun Apr 25, 2004 11:32 pm

#4

As far as making dasher/pup DNA in the 8k ham range the only way I know how to even attempt to do that would be to gimp every other aspect of the DNA template to the point that the clone would be basically garbage.

For the dasher/pup all you want to do is exp once in psy and mind. Make sure the DNA you're using for the dasher doesnt have hardiness over 450 for the psy slot or you are bound to hit CL11

Message Edited by SomeUser on 04-26-2004 01:33 AM

Vezek

Bio Engineer Archive

Thread: Cl-10 what is possible?!?!?