Bio Engineer Archive

I seem to get about a 230 point Stim "B" with standard experimented components. I get about 320 with advanced experimented components. Does this seem about right to everyone? Or should I be getting higher numbers using advanced components.

Does anyone have a spread between swith Stim "C" using advanced medical components vs standard? OR using say a standard CRM with advanced BEC and LS so as not to have to chase down all that freakin herb meat...

Check out this thread

http://forums.station.sony.com/swg/board/message?board.id=bio-engineer&message.id=33112

Using normal CRDM with ALS and ABEC, my current C's are about 1050 or so power. With the same ALS and ABEC, the same stims are at 1080 power.

Not a huge gain, really. If there was any uber-quality FB around I could get more out of it than the ACRDM.

Of course, it wouldn't hurt if the best ABEC's on Bria were better than the 16/15 they are right now since good HQ Tatt fiber hasn't been available in pretty much forever

The end result is highly dependent upon the resources you use throughout the entire process. Crummy Dantooine Berries or Herbivore Meat can have a dramatic impact on the final stim that you're producing.

If you want really good results, these are the kinds of things you're going to want to look for:

• CRDM's with 50+ Power


• LS's with 150+ Power


• BEC's with 18+ Charges or Power

If any of those subcomponents are falling well short of those numbers, you're going to have a hard time getting high powered stims (350+ power). Also, make sure that the resources you're using to combine the stim itself are VERY high quality. There is a lot of power to be gained by experimenting on a stim and you want every ounce of that available to you. Good resources make it happen.

Thank you for the link. That waskick butt explination....... I owe you big time.