Bio Engineer Archive
Thread: How do you determine a Draft Schematic Number?
Page 1 of 1
Ixtli
Mon Apr 12, 2004 4:25 am
#1
In reading the BE FAQ I came across the following macro command....
/selectDraftSchematic 158
I would like to know I am able to tell the number of the draft schematic that I am suppose to use. the draft schematics don't have any corresponding numbers to them so where did the inventor of the macro of this get this number from? (Note I said inventor because the author admits that he did not create the macro)
Complete answers only please pertaining to this question,
Thanks in advance,
RAma2003
Mon Apr 12, 2004 4:32 am
#2
Only way I know to do it is to open your crafting station and manually typ /selectdraftSchematic ## and hit enter. Not the schematic you are looking for? Try the next number...
Every time you train in a new box you get new schmatics (for most boxes) and the numbers shift, so you have to find the correct schematic# again (should be pretty close to the old # you found it to be before)and edit your old macros.
Lightburn
Mon Apr 12, 2004 5:31 am
#3
ok basicly this can be easy once you know what you are doing.
ok press ctrl d - draft schematic
if u r a doc and grinding up artisan ur doc schematic will be like 00 wich will be like advanced bio controller
so what you do is find the item you want to make. Then count left to right all the way to it and then what eva number it is type thanumber ie say u had a table what was 57 down the list you would type /selectDraftSchematic 57;
BUT the fastest way is guess a number of whereabouts its near ie its 4 rows down and then say ok 34 then count on from the 34 til u get to 42 (the item) then you know what number it is
ArmAvan
Tue Apr 13, 2004 6:12 am
#4
OK, open your schematics Tab. Then count the number of schematics to the one you want, EXCLUDING all schematics which CAN'T be made with that tool, ie camps, traps etc. Once you reach your selected schematic, subtract 1 from that number and that is the schematic number you want.
Ixtli
Tue Apr 13, 2004 8:05 am
#5
Do I also use this metnoid with the ingredence as well or do I use a pause command to select them?
porphyria
Tue Apr 13, 2004 8:13 am
#6
they have to be put in by hand. Unless you breal TOA (not recomended) and use a 3rd party program.
Page 1 of 1