Bio Engineer Archive
Thread: BE Tissue Factory Runs
Page 1 of 1
droid327
Wed May 12, 2004 6:54 pm
#1
Whats the most you can get in a factory crate for tissues? Is there a cap?
And whats a good guideline for pricing crates?I was going by333 * +mod * # in crate, is that below market or too much?
Shivash
Wed May 12, 2004 8:22 pm
#2
crates are 25 items however all crates in the same run will have the same serial and thus the contents can all be used in one factory run. That maximum therefore is 1000, from 40 crates.
Pricing of tissues is tricky - depends on which type your talking about.
Stims tend to be
power x use / 10
Chef tissues vary - I'm on the cheap side at
15/25/35 for small/med/large
I used to charge 25/35/50.
Tailor tissues not really worked out pricing yet.
Pricing of tissues is tricky - depends on which type your talking about.
Stims tend to be
power x use / 10
Chef tissues vary - I'm on the cheap side at
15/25/35 for small/med/large
I used to charge 25/35/50.
Tailor tissues not really worked out pricing yet.
droid327
Thu May 13, 2004 3:51 pm
#3
so if i stick in enough resources for, say, 50 items, will it make2 crates of 25? or will I need to take the crate out after 25 and restart the factory?
obeewan
Thu May 13, 2004 6:37 pm
#4
You can make a schematic for 1000 items, when you fill the input hopper *That* controls how many items are made.
Once the machine starts, you need do nothing but wait till it's finished. While it is in operation, you can (i believe it is) right click on machine options to open the output hopper without stopping the machine=)
Page 1 of 1