Artisan Archive

I can't seem to get a response in any forums.

I bought a factory and made a schematic and put it in the schematic slot. I then paid maintenence and put some energy in.

First the ingredients listed thatI need are in another langaugae like ount and ikotep. I'm making flow analyzer nodes and I know they take 20 steel and 20 copper for each one. So I put in 2k of each copper and steel and start it up.

When I start it up I get an e-mail a minute later that says its done and 0 products were made. It also takes 10 of my steel everytime yet no products.

What am I doing wrong?I even split them into 1k steel, 1k steel, 2k copper like it is when doing them solo. So right nowI'm at a total lost of what's wrong. Thanks for the help.

All I can think of to check is that the materials you used to make the schematic are the same ones going into the factory. If it's not that then it sounds like a bug.

Do they have to be of the exact same quality? I may have mixed and matched there, I'll try that.

Thanks, I had used diff quality for the schematic and that's why it was taking 10 of the first one and not the second because the first was in the schematic.

Yeh, has to be exact same. I ran into that as well my first time using factory.

Hope it works for you now.