Artisan Archive
Thread: Someone plz help me...
Page 1 of 1
Danemb
Mon May 03, 2004 6:14 am
#1
Hi...
I found this crafting-macro on the forum:
/ui action toolbar slot xx;
/selextdraftschematic xx;
/pause 10;
/next crafting stage;
/next crafting stage;
/createprototype;
/createprototype;
I will use it to make MSE droids faster to get xp, not to hologrind.
In the selcct schematic fase how do i know which schematic number i shall write?
And will this macro work?
I would appreciate fast help
Danemb
Mon May 03, 2004 6:27 am
#3
It says:
The crafting session has ended two times when i use the macro...
Why?
GrafvonSoden
Mon May 03, 2004 9:53 am
#4
Basically , you will need to experiment to get right number for crafting schematic. Open data window to crafting schematics and count number of schematics, until you get to one you want. Then subtract one because computer starts with 00. Try this and it should get you close. If it is not the one you want, then see how close what you did get it is to the one you want and adjust your number accordingly.
Anubi
Mon May 03, 2004 11:20 am
#5
also, the proper syntax is
/ui action toolbarSlotxx
where xx is the number of the toolbar slot that the tool is in. The syntax has to be exact, or it will not work. Also note that the toolbar slot number must be two digits.
Page 1 of 1