Armorsmith Archive
Thread: RIS Layers question.
Page 1 of 1
Centauros
Sun Dec 12, 2004 3:21 pm
#1
I tried searching but I couldn't find anything specific. My question is if you make RIS Layers, and experiment fully on HAM, what will the -HAM come out to be? Can you people please post the stats of the resources you used for the layers, as well as the H/A/M and base please? Thank you! (Also say if you are 10 or 12 pointer please)
TalynMox
Sun Dec 12, 2004 6:40 pm
#2
12pt, don't remember what resource stats were (all I rember was that they weren't exactly sterling). With full experimentation into HAM they came out with -8 to all, and about 2.xx - 3% base. Will update with stats when I have the chance to trawl through my resource storage.
Centauros
Sun Dec 12, 2004 7:09 pm
#3
Thanks, let me know if you can find the stats on those resources. Were you able to fill the HAM in 10 points (I assume you were)?
Centauros
Sat Jan 15, 2005 9:43 pm
#4
Can anybody give me the stats on RIS layers you can make, if they are fully experimented towards HAM?
Or perhaps the formulas to figure out these stats. If possible post the stats of what resources you used for comparison too please
Or perhaps the formulas to figure out these stats. If possible post the stats of what resources you used for comparison too please
Govo
Sun Jan 16, 2005 10:14 am
#6
I do know you can get negative HAM stats using resources that most master armorsmiths have.
Centauros
Sun Jan 16, 2005 10:30 am
#7
Yea I know, I am trying to figure how low into the negatives they can get as well as the base on them.
Message Edited by Centauros on 01-16-2005 09:31 AM
CharPrime
Sun Jan 16, 2005 4:04 pm
#8
it will depend on your resources. i played around with a few. max out on ham first, then base
3% base ham -8/-8/-8
Message Edited by CharPrime on 01-16-2005 05:06 PM
Page 1 of 1