Armorsmith Archive

Ok, I know that the quality of resources for the components that an armorsmith makes doesn't matter when making them for th MK3's. My question is what about the components made by a master artisan? Can I use grinding resources for these too?

Doesnt seem to matter.. I put quality stuff into the components, experimented the durability upto 87% on all components (effect was about 17% or so from memory). Built a shield, came out (after experiment) to about just over 20% resists.. and 1.1k of durability ( )

Did the same and used high 80's experiments on the components to effectiveness.. durability was approx 15-17%.. Put the shield together and experimented.. same results as the first one..

Would think if you leftall componentsall low %, it probably wouldnt make a difference..

/shrug.. But it might be just me.. Would be interested to hear if its not the case though

The master artisan components really don't matter either I haven't seen any difference in all the MK III shields I've made over the past 3 months. Just make sure you have the best materials for the final build and you're good.

Thanks you for your reply's.

It might not affect the final product quality, however... I believe it *does* impact your experimentation chances...

ie: You'll have a better chance of successful experimentation with fully experimented components. NOTE: This is a theory.

Doesnt seem to matter.. I put quality stuff into the components, experimented the durability upto 87% on all components (effect was about 17% or so from memory). Built a shield, came out (after experiment) to about just over 20% resists.. and 1.1k of durability ( )

Did the same and used high 80's experiments on the components to effectiveness.. durability was approx 15-17%.. Put the shield together and experimented.. same results as the first one..

Would think if you leftall componentsall low %, it probably wouldnt make a difference..

/shrug.. But it might be just me.. Would be interested to hear if its not the case though