Armorsmith Archive

Ypsilon
Master Weaponsmith
Galactic Trade and Exploration Network (G10)

Hello everyone.

I'm a new smith, (currently 0/1/0/4), and was wondering if there was a way to add an energy layer to my Mbarie armorweave segments.

I noticed in JattoWaals Guide, above, he makes refernce to adding a "light energy layer" to Mbarie. Is that different from the energy layers I can make with Layers 1?

Thanks In advance

Margali

Intrepid

Margali
Many faces, many names, many worlds...Always me.

The only way to take out the energy vuln from maberi, is to add segment enhancers. That would be krayt scales and voritor scales ( not segs) mostly.

Newmoon Tirgwystraff
Resident of Mr. Ploppy's Turtle-Flavored Ice Cream Kingdom
" English doesn't borrow from other languages. English follows other languages down dark alleys, knocks them over, and goes through their pockets for loose grammer. "

And using these above mentioned scales will only yield you a paultry 4%, althogh as mentioned, it would remove the vulnerability. In may opinion, the best way to handle Mabari is to raise your base as high as possible on you advanced segment, and leave the Primary resis ( Heat ) alone. By doing this you can yield a decent 23-28% Kinetic resist,and use it for low level creature missons. It is actually quite effective that way as cheap armor for beginners, and it looks great also.

Alternatley, on the higher end, you could add that Krayt scale and net an abundance of resists, but this approach can be costly, and the resistence percentages would be almost negligible.