Armorsmith Archive
Thread: Layer Factory Times borked?
Page 1 of 1
Katosan
Fri May 13, 2005 2:39 pm
#1
The time on my schematic is 283 per item, but this morning, which would have been day 1.5 the factory was only on item #352
Why is it taking longer than it should?
Mcgreag
Fri May 13, 2005 2:53 pm
#2
Extended server downtime when you where sleeping perhaps?
352 layers at 283 sec per layer should take 27.8 hours so it's not that much off.
352 layers at 283 sec per layer should take 27.8 hours so it's not that much off.
Carthax
Sat May 14, 2005 4:41 am
#3
Good way to keep the factory times down is to limit the number of experiments you do. Every time you experiment you increase the complexity and thus the time it takes to make.
If you know you're going to stick 8 points in 1 line and 4 in the other dont go 2+2+2+2 then 2+2, it will shorten your times by going 6+2 then 4 on the exp lines. Lower complexity for the win, but it still takes a stupid amount of time. I'm on my second day of waiting for unlayered segs to finish.
If you know you're going to stick 8 points in 1 line and 4 in the other dont go 2+2+2+2 then 2+2, it will shorten your times by going 6+2 then 4 on the exp lines. Lower complexity for the win, but it still takes a stupid amount of time. I'm on my second day of waiting for unlayered segs to finish.
Katosan
Sat May 14, 2005 2:16 pm
#4
Took three days total... that's almost triple what the schematic said.... weren't that many down times that I saw.
GatorSpear
Sat May 14, 2005 2:33 pm
#5
Interesting..... also I am only seeing one line for experimenting on layers... is that correct after CU?
Mcgreag
Sat May 14, 2005 4:14 pm
#6
Katosan wrote:
Took three days total... that's almost triple what the schematic said.... weren't that many down times that I saw.
How are you counting?
1000 layers at 283 sec per layer = 78.6 hours or 3.3 days. Taking just as long as it's says it will.
Page 1 of 1