CUEmu - Thread Posts

KaneSulaco

Thu Jun 24, 2004 3:36 pm

I was crafting some layers last night and I noticed some of them would not experiment any higher,

E.G: My layer would start at say 6% I have A/S 3103 (3k away from 3104) I could improve it may be once or twice say to 10% and then no matter what type of success I would get from then on it would not rise above 10%.

Is this some kind of bug? I was going from a success of say 34-46 and the base would not rise anymore.

I played around with this and found it was the same on Durability and Quality.

Is there a cap on your success %%% ?

__________________________________________________________________________________________

Kaine Sulaco(SC)
A plan is just a list of stuff that never happens!
__________________________________________________________________________________________

owako

Thu Jun 24, 2004 4:41 pm

#2

Sounds like you hit the exp cap with the resources you are using. Basicly suck resources have a low exp max, while high quality resouces allow you to experiment them much higher. Pretty much everythign in armorsmithing needs high OQ and SR, check your resources, if on or more is low in either OQ or SR that might be limiting how high you can go, even if you have exp points available.

Only two things are infinite, the universe and human stupidity, and I'm not sure about the former.
Albert Einstein

KaneSulaco

Thu Jun 24, 2004 4:47 pm

#3

Oh cool, thanks for that.

I was going off OQ and MAL.

__________________________________________________________________________________________

Kaine Sulaco(SC)
A plan is just a list of stuff that never happens!
__________________________________________________________________________________________

owako

Thu Jun 24, 2004 7:45 pm

#4

MALL is used, but for the encum, OQ and SR determine the resists.

Only two things are infinite, the universe and human stupidity, and I'm not sure about the former.
Albert Einstein

Armorsmith Archive

Thread: Is this a crafting Bug?