Architect Archive

for some odd reason my structure factory is not producing walls. This is the stragest problem i have faced. Thefactory will run for about three mins,Then i get the message that tells me0 item were produced.I check the ingedients hopper to make sure everything is there but all required resources for one wall are gone. ANd there is nothing in the outphopper.I have all the corresponding resources required in my blue prints so its not a resource problem. The is plenty of energy and credits in the factory so thats not the problem. Anybody else getting this problem?

They may have not fixed the schematic in the patch, I haven't checked. If you have structure mondules in crates, try removing 10 and putting them in the input hopper and see if it works. We may still be stuck at hand loading.

The thing is though that i never used structure modules in creates. I always hand loaded them into the factory, so the max i could make at one time was 9

Yup it is not producing walls for me either just ate up the resources

Yes... same thing here except making Structural Modules. It will eat the resources for one, then stop making. GRRRRRRR. Fix everyone else but keep screwing with us eh?? ARGH!

Mine worked fine,

Are you using a new or old schematic? I was using a new one ii just made

Happening to me too, tried with 2 schems too. It wont make structural modules either.

I freaked out when I read this but fortunately my factory works fine... Take note that output hopperitem limits have been reduced from 1000 items to 100, and that crates have a volume of 5. So, make sure your output hopper isn't full. If that fails, maybe try redeeding and replacing it?

there is NOTHING in my output hopper. I have made a new wall module schematic. I have unpacked modules in the ingredient hopper. I am positive I have the right ingredients. Yes it chews up ALL the resources needed to make one wall. When you have an ingredient issue it stops on the bad ingredient and doesn't take it. I have chewed a few thousand ore now trying to figure out what, if anything, I am doing wrong and can find nothing. I made a hundred stucture modules this morning post patch though so they factory works, but it will not make wall units. Someone pointed out that wall units are no longer mandatory factory mad for some things but that shouldn't effect the fact that if you want to make them in the factory you can.

I just checked my factory.

When I stopped it I had 19 Structural Modules in the output.

I checked the input hopper and the correct amount of resources were deducted from the ingrediants. They are properly being placed into the Factory containers which are taking up 5 item slots.

I am making a run of 150 structure modules and so far so go.