Architect Archive

Hi, can someone confirm if I'm doing this right?

I want to make 6 Power Core Modules in a factory run.

I have plenty of resources (LGO, Carb Ore, Steel, Non-Ferrous Metal). I also have six of each subcomponent: Generator Turbine, Power Conditioner, Energy Distributor.

My schematic uses the very same resources that I'm going to use in my factory run, although the subcomponents have been put together from what I had in stock - except the gen turbines, as the ywere made in a batch.

I've filled in the ingredient hopper with enough of everythign to make 6 PCM's. I input the schematic and start manufactirung....

... About 3 mins later I go back to check my factory, and it appears to have stopped manufacturing items. Nothing in the output hopper, nothing taken from the ingredient hopper. No message to say the facotry had stopped. In the three minutes up to this, the factory appears to be running fine, the only option being to stop manufacturing items. ANythign past this, and the control menu goes back to "Start Manufacturing".

Is it something I'm doing wrong?

Hello

Not sure all sub conponents need to be from factory crates.

mintas

The subcomponents that are put into the factory need to have the same serial numbers as the subcomponents used in the schematic. In other words, those subcomponents need to be made in the factory themselves.

If you are making6 Power Core Modules then you need to make at least 7 of each subcomponent. 1 of each is then used to make the schematic for the Power Core Module, the other 6 of each then go into the factory along with the singular resources used to make the schematic.

Keska Rayburn

Master Architect - Master Artisan - Novice Pistoleer

Avalon, Tatooine, Gorath