Architect Archive

I have a fleet of Fusions, I don't make them I just man them.

Can someone tell me if my old fusions are better or worse with the condition of the latest patch? I hear both good and bad but not being an acrhitect I have no means to test or full comprehend what I need to be concerned about.

Thank you in advance for the information.

Currently the best rate of extraction is 16 for fusions, If you had your fusions in the ground harvesting they are probably still 13, if you had them in your backpack, they might have been bugged and now harvest at a rate between 22-29.

They were in the ground so they have a rate that is lower than a possible bug?

So that is BAD for me correct?

In the long run I'm I potentally in a better or worse situation, with 20 fusions already in the ground?

i dont know where u get the best rate of extraction being 16.. I have one that does 25 KGH

From what I and others have seen those are pre patch fusions. Did you make those after that patch? I only made one so i could have been really unlucky and gotten a 16 extraction rate.

Prior to the patch there were two experimental phases that could change extraction rates. Post patch there is only 1. Some fushions made prepatch will have godly extraction rates over 20 most will have baseline 13's. Anythine made post patch will be baseline 13 or higher, but not reach the godly rates of 20 and above. If caps are similar on fusions as on regular harvesters expect the highest experimental post patch fusions to be in the 16/17 range.

Thank you Ndainye for the concise response.

Didn't the devs say that changes in the extraction rate were a piece of old code that wasn't supposed to go live because extraction rates were supposed to be handled by concentration percentages??