Architect Archive
Thread: Do OMU's need quality with fusion harvesters ?
Page 1 of 1
Poldano
Tue Jun 14, 2005 5:02 pm
#2
I'm quite sure this is in the FAQ.
Yes, and good materials in the final combine, for BER 14.
Saego, Wanderhome.
Thrstbster
Wed Jun 15, 2005 6:56 pm
#3
Well to make the BER 14 schem it needs to be a good OMU but in the factory it doesnt matter. Make a run of the worst ones you can and only use one good one. I bet they didnt intend for it to work that way but it does. If it didnt I think that Fusions prices would increase around and the power prices increase and then everyhitng else does. Its funny how energy does that does it not? I cant wait for my 20% increase in electrical power on my next bill in RL.
ZenDragonMLS
Thu Jun 16, 2005 8:31 am
#5
Thrstbster wrote:
Well to make the BER 14 schem it needs to be a good OMU but in the factory it doesnt matter. Make a run of the worst ones you can and only use one good one. I bet they didnt intend for it to work that way but it does. If it didnt I think that Fusions prices would increase around and the power prices increase and then everyhitng else does. Its funny how energy does that does it not? I cant wait for my 20% increase in electrical power on my next bill in RL.
Yes, there is a bug where you can use a premium OMU to make a schematic for fusions, and then dump in junk OMUs into the input hopper. Since its a bug you should think about it before you depend on it. In my case I make premium OMUs and only use them.
Page 1 of 1