Architect Archive
Thread: Harvesters eating too much enery? NO! It's a display problem...
Page 1 of 1
SwiggyMidget
Sun Dec 14, 2003 2:37 pm
#1
And I found a way to fix it...
Open the status window on your harvester. Keep it open. Now open the Operate Machinery window. Select Change Resouce and select the resource you are currently harvesting. Then hit OK. Now on the Status window hit refresh. Tada, you now see the correct amount of energy in your harvester.
Have Fun!
Swiggy
Leowyiak
Sun Dec 14, 2003 4:33 pm
#2
it also works if you turn your harvester off, then on...
unless this is done for me, my harvesters always show 600-1200 less energy than they have (down to 0).... and they always revert to the bad display 60 seconds after i check them (this is also linked to the harvesters not animating going up and down if you dont turn them off and back on...)
Page 1 of 1