Architect Archive
Thread: Macro woes
Page 1 of 1
umdesch4
Fri Apr 16, 2004 8:28 pm
#1
I've seen a few posts scattered throughout the board talking about problems with the basic crafting macro. Here's an example that pretty much sums it up:
I can't get this macro to work either. I systematically tried this out line by line to see where the hangup was. Here's where I'm running into problems: after selecting the schematic, I manually input the resources (hence the pause). This is where it hangs up. It just stays on the schematic page, even though I have the pause set to 6 secs. So I manually hit "next" and get a message saying that the schematic resources have not been met (even though they are). So I tried increasing the pause time and the same thing happens. I increase it to 35 secs and it's still stuck on the same screen but when I hit "next" it let's me move on this time. Anyone have any idea why it's doing that? I'm following this macro to the very letter and am still having a hard time. Thanks in advance.
In all of these cases, it seems like the /nextCraftingStage; line just doesn't work. Does anyone out there know why this happens?
umdesch4
RumbleSteelskin
Sat Apr 17, 2004 11:22 am
#2
I'm a macro-nut and I use the crafting macro all the time.
Make sure you're not standing next to a Crafting Station, as that can throw the macro out of wack.
Otherwise, type your macro out here and I'll see if I can help you with it.
Page 1 of 1